KRUPS SERIE EA9000
38
9
Replace the two drip trays (see visuals p. 13).
The manual steam nozzle cleaning cycle is finished.
Press OK to confirm and quit.
Caution: The manual cleaning of the nozzle and the cleaning container must be carried out in this
sequence: If not, you risk damage to the steam nozzle assembly, malfunction or breakage.
!
6
The steam tube moves down.
You can thus clean it properly with a damp cloth (you can use a little
washing-up liquid, but rinse it thoroughly). The steam tube cannot be
dismantled.
Press the “OK” button. The steam tube moves up so that the nozzle tip
and the nozzle can be refitted.
7
Re-screw the nozzle with the tip onto the steam tube.
Press the “OK” button.
The steam nozzle assembly moves up and stops above the cleaning
container.
8
Cleaning the steam nozzle cleaning container (11).
Press YES to the question: “Do you want to clean your cleaning container?”
if you want to clean it.
Press the top of the container to remove it. Clean it under running water.
To put the container back, first position the lower part and then press the
upper part: you should hear a “click”.
Press the “OK” button.
To Next Page
Loading...
