18mm
Cable Housing
Ferrule
Locking Cable End
Inner Wire
11
Hold the free end of the cable and cable housing to the cable entry point.
Mark this length on the cable and cable housing with a marking pen or
tape.
Using a pair of bicycle cable cutters, trim the cable housing to this measured
length. DO NOT cut the inner wire at this time.
Option 1: Using a standard shifter cable.
Mark the inner wire to a length 18mm longer than the cable housing or use
the gauge molded into the supplied protective cap as shown:
Tighten the locking cable end to the cable using both a 3mm and 2mm Hex
wrench. Ensure the inner wire is flush with the locking cable end.
CABLE INSTALLATION
Ferrule
Cable
Cable Housing
3mm
2mm
Locking
Cable
End
End Cap
18mm
12 13
To Next Page
Loading...
