KTC COMPACK 2 ECO - Safety Symbols Explained; Read Instruction Booklet Before Operation; Attention Symbols and Meanings; Machine Stopped Operation

CONFIDENTIAL - This document is the property of K.T.C. S.r.l. and cannot be reproduced or issued to third parties without written
authorization. K.T.C. S.r.l. shall safeguard its rights to the full extent of the law.
OPERATION AND INSTALLATION MANUAL
COD. 091114 – COMPACK 2 ECO / SPECIAL - REV. 08 - DATE 10/2020 page 3 of 63
SYMBOLS USED
The following SYMBOLS are used throughout the course of this publication to draw the
attention of the operator to the behavior to be adopted in every operating situation
These symbols can be placed next to a text, next to a figure or at the top of the page. Pay the
utmost attention to the meaning of the symbols: their function is that of not having to repeat the
technical concepts or safety warnings, therefore to be considered "reminders". Consult the
table below whenever there are any doubts about their meaning.
READ THE INSTRUCTION BOOKLET
Before positioning, operating or working on the compressor, read the user and
maintenance manual carefully.
ATTENTION
highlights an important description regarding dangerous conditions, safety warnings,
information of the utmost importance.
STOPPING MACHINE
every operation must be carried out with the machine stopped.
CAUTION MACHINE IN PRESSURE
each operation must be performed with the machine without pressure inside the oil
separator tank (0 bar).
REMOVE TENSION
every operation on the machine must be carried out with the power supply switched
off.
QUALIFIED PERSONNEL
any intervention highlighted by this symbol is the exclusive responsibility of a
specialized technician.