Need help?Do you have a question about the KTM 150 EXC 2023 and is the answer not in the manual?
General| Engine Type | Single Cylinder, 2-stroke |
|---|---|
| Bore x Stroke | 58 mm x 54.5 mm |
| Transmission | 6-speed |
| Seat Height | 960 mm |
| Brakes | Disc brakes |
| Front Brake Disc Diameter | 260 mm |
| Rear Brake Disc Diameter | 220 mm |
| Ground Clearance | 370 mm |
| Displacement | 143.99 cm³ |
| Front Suspension | WP XACT 48 |
| Rear Suspension | WP XACT |
| Starter | Kick starter |
| Cooling | Liquid cooled |
| Clutch | Wet, multi-disc |
Explains the meaning of specific symbols used throughout the document.
Details the typographical formats used for names, brands, and terms.
Describes the vehicle's transport mode and the process to enable its electronics.
Identifies the location of the diagnostics connector on the vehicle.
Step-by-step guide for unpacking the vehicle and performing initial setup.
Instructions on how to safely raise the motorcycle using a lift stand.
Procedure for safely removing the motorcycle from a lift stand.
Step-by-step guide for removing the motorcycle seat.
Instructions for properly mounting the motorcycle seat.
Guide to installing the shock absorber with torque specifications.
Step-by-step instructions for installing the front fork legs.
Guide on installing the front wheel, including brake precautions.
Instructions for safely removing the 12-V battery, noting hazards.
Guide to safely charging the 12-V battery, including warnings.
Steps to install the 12-V battery into the compartment.
Procedure to disconnect the negative cable from the 12-V battery.
Procedure to connect the negative cable to the 12-V battery.
Instructions for removing the air filter box cover.
Instructions for installing the air filter box cover.
Steps for removing the rear left side cover.
Steps for installing the rear left side cover.
Instructions for positioning and mounting the front fender.
Guide to detach and remove the headlight mask and headlight assembly.
Steps to install the headlight mask and headlight assembly.
Procedure to check and verify the motorcycle's headlight alignment.
Instructions on how to adjust the headlight beam range.
Steps for attaching the engine guard to the motorcycle frame.
Guide to open the 2-stroke oil tank cap.
Instructions for closing the 2-stroke oil tank cap.
Guide on how to add 2-stroke oil, including warnings.
Steps to open the fuel tank filler cap.
Instructions for closing the fuel tank filler cap.
Safety precautions and steps for refueling the motorcycle.
Guide to change the unit of measurement on the display.
How to adjust functions and display modes on the instrument cluster.
Steps to set the time on the motorcycle's clock display.
Lists tightening torques for various chassis-related screws and nuts.
Details specifications and recommendations for 2-stroke engine oil.
Details specifications and guidelines for super unleaded fuel.
Information on long-life grease, including recommended supplier.
Explains the JASO FD classification for 2-stroke engine oil.
To Next Page