Why KTM Motorcycle engine does not speed up?
If the KTM Motorcycle engine does not speed up, it could be due to: the carburetor running over because the float needle is dirty or worn (check/set the carburetor components); loose carburetor jets (check/set the carburetor components); or a fault in the ignition system (check the ignition system).
Why KTM 300 XC-W engine cannot be cranked?
The KTM motorcycle engine might fail to crank due to several reasons. It could be an operating error during the start procedure. Alternatively, the battery might be discharged, requiring you to recharge it, check the charging voltage, closed current, and alternator. Other potential causes include a blown main fuse (replace it), a faulty starter relay (check it), or a defective starter motor (check it).
Why does my KTM 300 XC-W engine overheat?
Your KTM Motorcycle engine may be overheating due to several reasons: insufficient coolant in the cooling system, so check for leaks and the coolant level; not enough air stream, so switch off engine when stationary; dirty radiator fins (clean them); foam formation in the cooling system (drain and refill the coolant); a damaged cylinder head or cylinder head gasket (check them); a bent radiator hose (replace it); or an incorrect ignition point due to a loose stator (adjust the ignition for All 125 models).
Why KTM 300 XC-W Motorcycle engine has too little power?
A KTM Motorcycle engine might have reduced power for several reasons: interrupted fuel feed (check the fuel tank breather, clean the fuel tap, and check/set the carburetor components); a very dirty air filter (clean the air filter and air filter box); a leaky or deformed exhaust system, or insufficient glass fiber yarn filling in the main silencer (check the exhaust system for damage and replace the glass fiber yarn filling of the main silencer); a fault in the ignition system (check the ignition system); or a damaged diaphragm or reed valve housing (check them).
What to do if KTM Motorcycle engine stalls or is popping into the carburetor?
If your KTM Motorcycle engine stalls or pops into the carburetor, it might be taking in bad air, so check the intake flange and carburetor for tightness. Another possibility is that the connector or ignition coil is loose or oxidized, so clean the connector and treat it with contact spray.
Why KTM 300 XC-W Motorcycle engine has no idle?
If your KTM Motorcycle engine has no idle, the possible causes are: the idling jet is blocked (check/set the carburetor components); adjusting screws on carburetor distorted (adjust the idle speed); spark plug defective (change the spark plug); ignition system defective (check the ignition coil and the spark plug connector).
Why is there white smoke emission (steam in exhaust gas) from KTM 300 XC-W Motorcycle?
White smoke (steam) from the KTM Motorcycle exhaust gas is likely due to a damaged cylinder head or cylinder head gasket, so check the cylinder head and cylinder head gas- ket.
Why gear oil exits at the vent hose of KTM 300 XC-W?
If gear oil is exiting at the vent hose of your KTM Motorcycle, it's likely because too much gear oil was added. Check the gear oil level.
Why there is water in the gear oil of KTM 300 XC-W?
If you find water in the gear oil of your KTM Motorcycle, it's probably due to a damaged shaft seal ring or water pump. Check the shaft seal ring and water pump.
How to fix KTM Motorcycle engine stalling or popping into the carburetor?
If your KTM Motorcycle engine stalls or pops into the carburetor, it might be taking in bad air. In this case, check the intake flange and carburetor for tightness. Also, the connector or ignition coil may be loose or oxidized; if so, clean the connector and treat it with contact spray.
General| Displacement | 293.2 cc |
|---|---|
| Bore x Stroke | 72 mm x 72 mm |
| Starter | Electric starter |
| Transmission | 6-speed |
| Cooling | Liquid cooled |
| Front Suspension | WP XPLOR-USD, Ø 48 mm |
| Front Brake | Disc brake |
| Rear Brake | Disc brake |
| Ground Clearance | 370 mm |
| Seat Height | 960 mm |
| Engine Type | 2-stroke |
| Fuel System | Mikuni TMX 38 |
| Rear Suspension | WP Xplor PDS |
| Frame | Central double-cradle type 25CrMo4 steel |
To Next Page
