KTM 400 EXC AUS 2011 User Manual

301DISASSEMBLING THE ENGINE 111
- Unscrew bolts. and remove them with the washers and springs.
- Take
off the pressure cap.
-
Remove crankshaft location point •.
- Completely remove clutch discs •.
- Remove clutch pressure piece •.
- Block the clutch hub and primary gear using special tocl •.
I Gear quadrant (80029004000) ( .. p. 262)
• Info
I LH thread
-
Remove the nut.
- Bend the lock washer.
- Counterhold the inner clutch hub with the special tocl.
Loosen nut •.
I Clutch holder (51129003000) ( .. p. 255)
- Remove the nut with the lock washer. Dispose of the lock washer.
- Take
off inner clutch hub. and washer •.
• Info
I The washer usually adheres to the inner clutch hub.
- Take
off outer clutch hub •.
301DISASSEMBLING THE ENGINE 111
- Unscrew bolts. and remove them with the washers and springs.
- Take
off the pressure cap.
-
Remove crankshaft location point •.
- Completely remove clutch discs •.
- Remove clutch pressure piece •.
- Block the clutch hub and primary gear using special tocl •.
I Gear quadrant (80029004000) ( .. p. 262)
• Info
I LH thread
-
Remove the nut.
- Bend the lock washer.
- Counterhold the inner clutch hub with the special tocl.
Loosen nut •.
I Clutch holder (51129003000) ( .. p. 255)
- Remove the nut with the lock washer. Dispose of the lock washer.
- Take
off inner clutch hub. and washer •.
• Info
I The washer usually adheres to the inner clutch hub.
- Take
off outer clutch hub •.

KTM 400 EXC AUS 2011 Specifications

General

Engine Type	Single cylinder, 4-stroke
Compression Ratio	12.5:1
Transmission	6-speed
Front Suspension	WP USD 48 mm
Rear Suspension	WP PDS shock absorber
Fuel Tank Capacity	9.5 L
Cooling	Liquid cooled
Starter	Electric
Fuel System	Keihin MX-FCR 39
Front Brake	260 mm disc
Rear Brake	220 mm disc
Seat Height	960 mm
Ignition	Kokusan
Frame	Chromium-Molybdenum steel