ENGLISH
9
Hot-start device
The carburetor is equipped with a hot-start device which makes it easier to start
the engine when hot. Press the hot-start button
1 until it engages. This will
slightly lift the throttle valve. Once the engine is running, pull the hot-start button
back into its original position.
NOTE:
Always pull the hot start device back into the initial position as soon as the engine
is running. An activated hot starting device will have a negative impact on the
cold starting properties of the engine.
Shift lever
The shift lever is mounted on the left side of the engine. The position of the gears
is shown in the illustration. Neutral, or the idle speed, is located between first and
second gear.
Kickstarter
The kickstarter is mounted on the left side of the engine. Its upper part can be
swivelled.
WARNING
WHEN STARTING THE ENGINE, PUT ON MOTORCYCLE BOOTS IN ORDER TO AVOID INJURIES.
Y
OU MAY SLIP OFF THE KICKSTARTER
, OR THE ENGINE MAY STRIKE BACK WHEN KICKING NOT
VEHEMENTLY ENOUGH
.
Foot brake pedal
The foot brake pedal is disposed in front of the right foot rest. Its basic position
can be adjusted to your seat position (see maintenance work).
WARNING
I
F THE RESISTANCE IN THE HAND BRAKE LEVER OR FOOT BRAKE PEDAL FEELS
“SPONGY” (TOO
MUCH GIVE
), THIS IS AN INDICATION THAT SOMETHING IS WRONG WITH THE BRAKE SYSTEM.
D
ON’T RIDE YOUR MOTORCYCLE ANYMORE WITHOUT FIRST HAVING THE BRAKE SYSTEM LOO-
KED OVER BY A KTM DEALER.
Handlebar lock
The handlebar can be locked by means of the lock located on the control head.
Fully turn handlebar to right to lock, insert key, turn to left, press in, turn to right
and withdraw.
!
CAUTION
!
NEVER LEAVE THE KEY INSERTED IN THE LOCK. IF YOU TURN THE STEERING TO THE LEFT THE
KEY COULD GET DAMAGED
.
1
2,3,4,5
1
N
To Next Page
Loading...
