ENGLISH
4
Chassis number
The chassis number is stamped on the right side of the steering head tube. Write
this number into the relevant area on page 1.
Engine number, engine type
The engine number and engine type are stamped on the right hand side of the
engine below the chain sprocket. Write this number into the relevant area on
page 1.
Clutch lever
The clutch lever 1 is fitted on the left hand side of the handle bar. When engine
is cold, there should allways be a play of 1–3 mm (0,04–0,1 in) at this lever (mea-
sured at outer edge).
!
CAUTION
!
I
F THERE IS NO PLAY ON THE CLUTCH LEVER, THE CLUTCH WILL START TO SLIP. THE CLUTCH
WILL THEN OVERHEAT
, DESTROYING THE CLUTCH LININGS.
Hand decompression lever
The hand decompression lever
2
is only used in two special cases:
a) When the engine stalled.
When you then start the engine, you may feel a hard resistance on the kickstar-
ter, because the automatic decompressor cannot lock into place. If this happens,
pull the hand decompression lever and stand on the kickstarter. You can then
start the engine normally again.
b) When you want to push-start the motorcycle.
While pushing, pull the decompression lever to make it easier to get the engine
going.
!
CAUTION
!
THE SETTING OF THE DECOMPRESSION CABLE SHOULD BE REGULARLY CHECKED. A LACK OF
PLAY IN THE DECOMPRESSION LEVER CAN RESULT IN ENGINE DAMAGE
.
1-3 mm
1
2
SERIAL NUMBER LOCATIONS
OPERATION INSTRUMENTS
To Next Page
Loading...
