EasyManua.ls Logo

KTM 690 ENDURO EU 2009 - User Manual

KTM 690 ENDURO EU 2009
181 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
OWNER'S MANUAL 2009
690 ENDURO EU
690 ENDURO AUS/UK
ART. NO. 3211357en

Table of Contents

Other manuals for KTM 690 ENDURO EU 2009

Questions and Answers

  • K
    Kristi LeeAug 19, 2025
    Why KTM 690 ENDURO EU 2009 Motorcycle engine turns but does not start?
    • C
      Charles RiosAug 19, 2025
      If the KTM Motorcycle engine turns over but doesn't start, it could be due to an operating error, so ensure you're following the correct start procedure. A blown fuse 4 could also be the problem. Check that the coupling of the fuel hose connection is properly connected. Another potential issue is an oxidized socket connector of the cable harness; clean it and treat it with contact spray.
  • T
    Tammy CareyAug 22, 2025
    What to do if the KTM Motorcycle engine does not turn when the starter button is pressed?
    • J
      Jim AndrewsAug 22, 2025
      If the KTM Motorcycle engine doesn't turn when you press the starter, there are several potential causes. It could be due to an operating error, so ensure you're following the correct start procedure. The battery might be discharged, requiring a recharge, and you should also investigate why it discharged. Check fuses 1, 2, 3, and 4, as a blown fuse could be the culprit. The main fuse could also be burned out. The ignition/steering lock or emergency OFF switch might be defective, or there could be a defect in the safety start system. Finally, a missing ground connection could prevent the engine from turning.
  • E
    Eric CampbellAug 25, 2025
    Why does my KTM Motorcycle engine overheat?
    • G
      gharrisAug 25, 2025
      Several factors can cause a KTM Motorcycle engine to overheat. You might have too little coolant in the cooling system, potentially due to a leak. The radiator fins could be very dirty, reducing their efficiency. Foam formation or air in the cooling system can also lead to overheating. A buckled or damaged radiator hose, a defective thermostat, or a blown fuse 5 could be the cause. Lastly, a defect in the radiator fan system could prevent proper cooling.
  • B
    Brandon BrownAug 26, 2025
    What to do if my KTM 690 ENDURO EU 2009 Motorcycle engine dies during the journey?
    • G
      Gregory CruzAug 27, 2025
      If your KTM Motorcycle engine dies while you're riding, the issue could be due to a lack of fuel, so refuel your motorcycle. Another possible cause is a blown fuse (1, 2, or 4), so check and replace any blown fuses.
  • R
    ryanschneiderAug 28, 2025
    Why KTM 690 ENDURO EU 2009 engine has too little power?
    • J
      James MccormickAug 28, 2025
      A KTM Motorcycle engine might lack power for a few reasons. The air filter could be very dirty, restricting airflow. Similarly, a very dirty fuel filter can impede fuel delivery. A defect in the fuel injection system could also cause a power loss.
  • C
    Christopher HopkinsAug 30, 2025
    What to do if KTM 690 ENDURO EU 2009 Motorcycle FI warning lamp (MIL) lights/flashes?
    • W
      wdorseyAug 30, 2025
      If the FI warning lamp (MIL) lights or flashes on your KTM Motorcycle, it indicates a defect in the fuel injection system.
  • T
    thorntonbriannaSep 1, 2025
    Why does my KTM 690 ENDURO EU 2009 engine only turn if the clutch lever is drawn?
    • J
      Jeff SchneiderSep 1, 2025
      If the KTM Motorcycle engine only turns when the clutch lever is pulled, it could be because the vehicle is in gear. Shift the gear to neutral. The vehicle might also be in gear with the side stand extended, so shift to neutral. A defect in the safety start system is another potential cause.
  • T
    Tony WallSep 3, 2025
    Why does my KTM 690 ENDURO EU 2009 have high oil consumption?
    • I
      igreenSep 3, 2025
      High oil consumption in your KTM Motorcycle can stem from a couple of reasons. Check if the engine vent hose is bent, and if so, reroute it without bends or replace it. Also, verify that the engine oil level isn't too high.
  • P
    pzhangSep 6, 2025
    How to fix KTM Motorcycle headlight and parking light not functioning?
    • J
      jacksonwilliamSep 6, 2025
      If the headlight and parking light on your KTM Motorcycle are not working, the issue is likely a blown fuse 7. Replace the fuse.
  • C
    Courtney CurtisSep 8, 2025
    How to fix KTM Motorcycle flasher light, brake light and horn not functioning?
    • C
      crystalsmithSep 8, 2025
      If the flasher light, brake light, and horn on your KTM Motorcycle are not working, the problem is likely a blown fuse 6. Replace the fuse.

Summary

Important Notes on Motorcycle Usage and Safety

Use Definition

Defines the intended use of KTM sport motorcycles for road and offroad operation.

Maintenance, Warranty & Parts Guidance

Emphasizes correct maintenance, warranty conditions, and approved parts usage.

Safety, Transport & Environmental Precautions

Covers transport safety, environmental responsibility, and explanation of risk grades.

Vehicle Identification and Specifications

View of Vehicle Components

Illustrates and labels key components from front-left and rear-right views.

Serial Number and Part Number Locations

Shows where to find chassis, engine, key, fork, and shock absorber numbers.

Controls and Instruments Operation

Handlebar Controls Overview

Describes levers, switches for lights, horn, starter, kill switch, and ignition.

Combination Instrument Functions

Details speedometer, tachometer, indicators, trip meters, and display settings.

Other Vehicle Controls

Explains filler cap, seat release, footrests, shift lever, brake pedal, and side stand.

Operation and Riding Guidance

Preparation and Running-in Procedures

Provides general tips for first use and engine running-in procedures.

Riding Instructions and Safety

Covers starting, shifting, braking, stopping, parking, and refueling.

Maintenance and Service Schedule

Service Schedule Overview

Outlines important maintenance work for authorized KTM workshops.

Chassis and Engine Maintenance Procedures

Detailed steps for fork, shock absorber, chain, brakes, oil, and filter maintenance.

Troubleshooting and Technical Data

Troubleshooting Common Issues

Lists faults, possible causes, and recommended actions for engine and electrical issues.

Flashing FI Warning Codes

Explains FI warning lamp codes and their potential causes.

Technical Specifications Summary

Provides detailed data for engine, chassis, fork, and shock absorber components.

KTM 690 ENDURO EU 2009 Specifications

General IconGeneral
BrandKTM
Model690 ENDURO EU 2009
CategoryMotorcycle
LanguageEnglish

Related product manuals