ENGLISH
36
MAINTENANCE WORK ON CHASSIS AND ENGINE »
Adjusting the headlight range
The payload can make it necessary to correct the headlight range.
The headlight range can be adjusted with the adjusting screw [1]. Turning in
a clockwise direction will increase the headlight range, turning in a counter-
clockwise direction will reduce the headlight range.
TO CHECK:
Make a mark on a light wall behind a level surface at a height of 830 mm
(32.7 in) (950 Adventure S) or 790 mm (31.1 in) (950 Adventure) respec-
tively. Position your motorcycle loaded ready for the trip (baggage, driver, pas-
senger) 10 meters away from the wall and switch on the low beam. The light/dark
cut-off line should be at the mark.
Replacing the brake and tail light bulbs
Remove the hexagon nuts [2] on the bottom of the fender and pull the tail
light off towards the rear.
BRAKE LIGHT BULB:
Turn the lamp socket [3] approximately 30° counterclockwise and pull it out
of the tail light housing. Slightly depress the bulb, turn it approx. 30°
counterclockwise and pull it out of the socket.
To mount the lamp reverse the worksteps indicated above.
TAIL LIGHT BULBS:
Pull the socket [4] out of the housing and pull the bulb out of the socket.
Replacing the flasher bulbs
Remove the screw on the back of the turn signal, carefully fold the lens [5]
towards the motorcycle and remove. Turn the cap [6] approx. 15° in a coun-
terclockwise direction and remove.
Slightly depress the bulb, turn it approx. 30° counterclockwise and pull it out
of the socket.
To mount the lamp reverse the worksteps indicated above.
1
2 2
4
4
3
6
6
5
To Next Page
