2 SETUP
3
2.1 Unpacking and setting up the vehicle
S00827-01
– Remove the straps and box.
S00823-01
– Remove the adhesive tape in the upper area of the motorcycle.
S00824-01
– Roll down the film at the sides.
Info
To avoid damaging the motorcycle during the setup,
leave the protective film on the vehicle until you have
finished.
– Unpack the separate enclosure and check its contents on the
basis of the enclosure list.
– Check the vehicle for transport damage.
S00825-10
–
Position damping rubber
1
on both sides.
–
Connect the plug-in connector
2
of the mirrors on both
sides.
– Position mirrors on both sides. Mount and tighten the screws.
– Position all controls in their exact positions on the handlebar.
Tighten all screws.
S00826-01
– Mount the reflector.
– Remove the protective plastic.
– Carefully loosen and remove the tensioning belt over the
swingarm.
Info
An assistant prevents the motorcycle from falling over.
– Carefully loosen and remove the tensioning belts around the
lower triple clamp.
The vehicle is released at the front.
– Take the vehicle off the pallet.
To Next Page
Loading...
