Why turn signal, brake light, and horn are not functional on my KTM RC 390 2018 Motorcycle?
If the turn signal, brake light, and horn are not functional on your KTM Motorcycle, it could be that fuse 6 is blown, so replace the fuse.
How to troubleshoot discharged battery on KTM RC 390 2018 Motorcycle?
A discharged battery in your KTM Motorcycle could be due to the ignition being left on while parked, so avoid leaving the ignition on when the vehicle is parked. Alternatively, the battery may not be charging due to an issue with the alternator. In this case, check the charging voltage and the open-circuit current.
What causes high oil consumption in KTM RC 390 2018?
High oil consumption in your KTM Motorcycle could be due to a bent engine vent hose; ensure the vent hose is routed without bends, or replace it if needed. Another cause could be an engine oil level that is too high, so check the engine oil level.
What to do if KTM RC 390 2018 Motorcycle engine overheats?
If your KTM Motorcycle is overheating, it might be due to foam formation in the cooling system. In this case, drain the coolant and then refill/bleed the cooling system. Other potential causes include a defective thermostat, a blown fuse 5 (so replace the fuses), or a defect in the radiator fan system, so check the radiator fan system.
What to do if the speedometer in combination instrument is not functioning on my KTM RC 390 2018 Motorcycle?
If the speedometer in the combination instrument is not functioning on your KTM Motorcycle, it could be that the speedometer wiring harness is damaged or the plug-in connector is oxidized, so check the wiring harness and plug-in connector.
What to do if the combination instrument shows nothing on the display of my KTM RC 390 2018 Motorcycle?
If the combination instrument shows nothing on the display of your KTM Motorcycle, it could be that fuse 7 is blown, so replace the fuse.
What to do if my KTM Motorcycle engine does not crank when pressing the electric starter?
If your KTM Motorcycle engine doesn't crank when you press the electric starter button, there are several potential causes. It could be due to an operating error, so ensure you're following the correct start procedure. The battery might be discharged, requiring a recharge. A blown fuse (1, 3, 4, or 7) could also be the culprit, so replace the affected fuse. Finally, check the ground connection to ensure it's properly connected.
What to do if my KTM RC 390 2018 Motorcycle engine dies during the trip?
If your KTM Motorcycle engine dies during a trip, it could be due to a lack of fuel, so refuel your vehicle. Another potential cause is a blown fuse (1, 3, 4, or 7), in which case you should replace the fuse.
How to fix KTM RC 390 2018 Motorcycle headlight and position light not working?
If the headlight and position light are not functioning on your KTM Motorcycle, check fuse 6 and replace it if it's blown.
Why KTM RC 390 2018 Motorcycle engine has too little power?
If your KTM Motorcycle engine has too little power, start by checking if the air filter is dirty and change it if necessary. Also, check the fuel pressure if the fuel filter is very dirty.
General| Displacement | 373.2 cc |
|---|---|
| Bore x Stroke | 89 mm x 60 mm |
| Compression Ratio | 12.6:1 |
| Torque | 36 Nm @ 7, 000 rpm |
| Transmission | 6-speed |
| Cooling | Liquid cooled |
| Rear Suspension | WP monoshock |
| Front Tire | 110/70 ZR17 |
| Rear Tire | 150/60 ZR17 |
| Seat Height | 820 mm |
| Ground Clearance | 178.5 mm |
| Fuel Tank Capacity | 10 liters |
| Dry Weight | 147 kg |
| Engine Type | Single Cylinder, 4-Stroke |
| Power | 43 hp (32 kW) @ 9, 000 rpm |
| Fuel System | Electronic Fuel Injection |
| Frame | Steel trellis frame |
| Front Suspension | WP upside-down Ø 43 mm |
| Front Brake | 320 mm disc |
| Rear Brake | 230 mm disc, single-piston caliper |
| ABS | Two-channel Bosch 9MB ABS |
Provides essential instructions for safe operation and highlights important labels.
Explains the different levels of risk (Danger, Warning, Caution, Note) and their symbols.
Details crucial safety aspects for operating the vehicle, including rider fitness.
Describes the location and function of the emergency OFF switch.
Explains the ignition and steering lock positions and functions.
Explains the various indicator lamps on the instrument cluster and their meanings.
Offers crucial safety advice and checks before the first ride.
Explains the procedure and limits for running in the engine.
Lists essential checks to ensure the vehicle is roadworthy before riding.
Details the procedure for starting the motorcycle's engine safely.
Explains how to apply the brakes effectively and safely.
Provides instructions and safety precautions for refueling the vehicle.
Lists periodic maintenance tasks and their recommended intervals.
Details how to inspect tires for cuts, damage, and tread depth.
Explains how to check and adjust tire air pressure for optimal performance and safety.
Provides step-by-step instructions for safely removing the motorcycle battery.
Guides on checking the coolant level in the expansion tank.
Guides on how to check the engine oil level correctly.
Details the process for changing engine oil and filter.
Lists possible causes and actions for a non-cranking engine.
Lists possible causes and actions for an engine that turns but doesn't start.
Lists possible causes and actions for an overheating engine.
Lists possible causes and actions for a red malfunction indicator lamp.
To Next Page
