What to do if my KTM RC 390 2019 engine turns but does not start?
If your KTM Motorcycle engine turns but does not start, it could be due to an operating error, so make sure to follow the correct start procedure. Another possible cause is an error in the electronic fuel injection, which requires reading out the fault memory using the KTM diagnostics tool.
Why is my KTM Motorcycle consuming so much oil?
If your KTM Motorcycle has high oil consumption, it could be due to engine oil that is too thin (low viscosity). To solve this, change the engine oil and oil filter, and clean the oil screens.
Why is the malfunction indicator lamp lighting up red on my KTM RC 390 2019?
If the malfunction indicator lamp lights up red on your KTM Motorcycle, it indicates an error in the electronic fuel injection system. To address this, use the KTM diagnostics tool to read out the fault memory.
What to do if my KTM RC 390 2019 engine does not crank?
If your KTM Motorcycle engine does not crank when you press the electric starter button, several issues could be the cause: * It could be due to an operating error, so make sure to follow the correct start procedure. * The 12-V battery might be discharged; in this case, charge the 12-V battery. * A fuse (1, 3, 4, or 7) might be blown, so replace the blown fuse. * There might be no ground connection; check the ground connection.
Why is my KTM Motorcycle engine overheating?
If your KTM Motorcycle engine overheats, it could be due to several reasons: * There might be too little coolant in the cooling system. Check the cooling system for leaks and inspect the coolant level in the compensating tank. * The radiator fins could be very dirty, so clean them.
What to do if my KTM RC 390 2019 Motorcycle engine dies during the trip?
If your KTM Motorcycle engine dies during a trip, it could be due to a lack of fuel; refuel the motorcycle. Alternatively, fuse 1, 3, 4, or 7 might be blown, so replace the blown fuse.
Why is the ABS warning lamp lighting up on my KTM RC 390 2019 Motorcycle?
If the ABS warning lamp lights up on your KTM Motorcycle, possible causes include: * A blown ABS fuse; replace the ABS fuses. * A large difference in wheel speeds between the front and rear wheels; stop the vehicle, switch off the ignition, and start it again. * A malfunction in the ABS; use the KTM diagnostics tool to read out the ABS fault memory.
Why does my KTM RC 390 2019 engine only turn if the clutch lever is drawn?
If the engine turns only when the clutch lever is drawn on your KTM Motorcycle, it is because the vehicle is in gear. Shift the transmission to neutral position. Also, if the vehicle is in gear and the side stand is folded out, shift the transmission to neutral position.
Why does my KTM RC 390 2019 Motorcycle engine have too little power?
If your KTM Motorcycle engine has too little power, the air filter might be very dirty, so change the air filter. Another possibility is that the fuel filter is very dirty, so check the fuel pressure. Finally, there could be an error in the electronic fuel injection, which requires reading out the fault memory using the KTM diagnostics tool.
Why does my KTM Motorcycle have high oil consumption?
If your KTM Motorcycle has high oil consumption, it could be due to a bent engine vent hose; route the vent hose without bends or change it if necessary. Another cause could be that the engine oil level is too high; in this case, check the engine oil level.
General| Engine Type | Single Cylinder, 4-Stroke, DOHC |
|---|---|
| Displacement | 373.2 cc |
| Torque | 36 Nm @ 7000 rpm |
| Transmission | 6-speed |
| Fuel System | Electronic Fuel Injection |
| Rear Brake | 230mm disc, single-piston caliper |
| ABS | Yes |
| Fuel Tank Capacity | 9.5 liters |
| Dry Weight | 147 kg |
| Seat Height | 820 mm |
| Frame | Steel trellis frame |
| Bore x Stroke | 89 mm x 60 mm |
| Compression Ratio | 12.6:1 |
| Front Tire | 110/70 ZR17 |
| Rear Tire | 150/60 ZR17 |
| Ground Clearance | 178 mm |
| Cooling System | Liquid cooled |
| Power | 43.5 hp (32 kW) @ 9000 rpm |
| Front Suspension | WP USD 43 mm |
| Rear Suspension | WP Monoshock |
| Front Brake | 320 mm disc |
| Top Speed | 170 km/h (approx) |
Provides general safety instructions and highlights warning labels on the vehicle.
Explains the different risk levels (Danger, Warning, Caution, Note) and their symbols.
Provides guidance on safe operation, including rider fitness and vehicle condition.
Emphasizes the importance of wearing appropriate protective clothing for safety.
Describes the location and operation of the clutch lever.
Describes the location and operation of the front brake lever.
Describes the location and operation of the throttle grip.
Describes the location and function of the emergency OFF switch.
Details the location and operation of the electric starter button.
Explains the operation of the ignition and steering lock.
Provides the procedure for locking the motorcycle's steering.
Provides the procedure for unlocking the motorcycle's steering.
Describes the location and gear positions of the shift lever.
Describes the location and function of the foot brake lever.
Details how to adjust the hand brake lever position for comfort.
Details how to adjust the clutch lever position for comfort.
Provides instructions for adjusting the shift lever length and angle.
Overview of the instrument panel, identifying key indicators and displays.
Explains various warning messages and indicator lamps on the display.
Details the function and meaning of different indicator lamps.
Explains the function and configuration of the shift warning light.
Describes how the coolant temperature is displayed using bars.
Explains how to set the first shift speed warning threshold (RPM1).
Explains how to set the second shift speed warning threshold (RPM2).
Offers essential advice and warnings before the first ride.
Details the procedure and limits for the engine break-in period.
A pre-ride inspection checklist to ensure roadworthiness.
Step-by-step instructions for starting the motorcycle's engine.
Guidance on how to begin riding after starting the engine.
Provides techniques for shifting gears and general riding practices.
Explains how to use the front and rear brakes effectively and safely.
Details the procedures for safely stopping and parking the motorcycle.
Provides essential safety information and steps for refueling the fuel tank.
Lists mandatory maintenance tasks and their recommended intervals.
Lists recommended maintenance tasks and their intervals.
Explains how to adjust the compression damping of the front fork.
Explains how to adjust the rebound damping of the front fork.
Details how to adjust the spring preload on the front fork.
Describes how to adjust the spring preload on the rear shock absorber.
Explains the function and components of the ABS system.
Procedure for checking the thickness and condition of brake discs.
Instructions on how to check the front brake fluid level.
Procedure for adding front brake fluid to the reservoir.
Procedure for checking the wear of the front brake linings.
Instructions on how to check the rear brake fluid level.
Procedure for adding rear brake fluid to the reservoir.
Procedure for checking the wear of the rear brake linings.
Guidance on checking tires for cuts, damage, and tread depth.
Instructions and importance of checking tire pressure.
Procedure for checking the coolant level in the expansion tank.
How to check the antifreeze concentration and coolant level.
Procedure for correcting the coolant level in the expansion tank.
Procedure for checking the engine oil level.
Steps for changing engine oil, oil filter, and cleaning oil screens.
Troubleshooting steps for when the engine doesn't crank.
Troubleshooting steps for when the engine turns over but doesn't start.
Troubleshooting steps for engine overheating issues.
Troubleshooting steps when the malfunction indicator lamp is red.
Troubleshooting steps for when the engine stops while riding.
Troubleshooting steps for when the ABS warning lamp is illuminated.
Table of specified tightening torques for engine fasteners.
Recommendations and specifications for fuel types and ethanol content.
Table of specified tightening torques for chassis fasteners.
To Next Page
