4.3 Multitplying factor
It can be set from 00.0001
up to 99.9999.
The decimal point is set to
4 decimal places.
„0“ is not accepted!
4.5 Decimal point
The decimal point defines
the resolution in the
selected measuring range
1/min or 1/sec
0 no decimal place
0.0 one decimal place
0.00 two decimal places
0.000
three decimal places
4.2 Switching on the 30 Hz filter
30 Hz filter off (f
max
)
30 Hzfilter on
It can be set from 00.0001
up to 99.9999.
The decimal point is set to
4 decimal places.
„0“ is not accepted!
4.4 Dividing factor
4.6 Display mode
Value conversion and
display in 1/s
Value conversion and
display in 1/min
4.7 Max. time to wait until „0“ is displayed
This parameter indicates, how long it takes, when
measuring is active, until „0“ is displayed.
Max. time to wait 00.1 s
(min. value)
Max. time to wait 99.9 s
4.8 End of programming
The programming routine
is repeated once more.
The values set until now
can be checked and mod-
ified.
The programming routine
wil be left and all values
set will be stored as new
parameters.
Afterwards the device is
ready for operation.
5
The filter provides input
damping*
* where bounce occurs, e.g. with contacts
To Next Page
Loading...
