Kubota D1703-BE - Timing Gear Anr Camshaft; Timing Gear Backlash; End Play of Camshaft; Camshaft Alignment

S.l ENGINE BODY
92.4mm STROKE SERIES WSM,01092
Crank gear
[2] TIMING GEAR ANR CAMSHAFT
Factory 0.0415 to0.1122 mm
spec.
0.001 6 to 0.0044 in.
\
CO 19F043
Idle gear
Cam gear
Factory 0.0415 toO.1154 mm
spec. 0,0016 to0.0045 in.
Allowable
0.1 5 mm
limit
0.0059 in.
I
ldlegear I fI$mble I 0.15 mm
0.0059 in.
I
End play of camshaft
Factory 0.07 to 0.22 mm
SPPC
Allowable 0.3 mm
limit 0.01 18 in.
0 0027 to0 0887 in.
~
I
0.0415 to 0.1 154 mm
spec. 0.0016toO 0045 in.
I Factory I
I ldlegear
I
0.0415 to0.1090mm
0.0016 to 0.0043 in.
I Crankgear
Allowable 0.15
rnrn
limit 0.0059 in.
End Plav of Camshaft
Camshaft Alignment
1. Support the camshaft with V-blocks on the surface
plate and
set a dial indicator with its tip on the
intermediate journal at right angle.
2. Rotate the camshaft on the V-blocks and get the
misalignment (half of the measurement).
3. If the misalignment exceeds the allowable limit,
replace the camshaft.
0.01 mm
I Camshaftalignment I i$Yble I 0.00039 in.
S-8 1