EasyManua.ls Logo

Kubota LX2610SU - Overheating Countermeasures; Checking Fuel Lines; Checking Intake Air Line

Kubota LX2610SU
154 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2. Replace
the hoses and tighten the hose clamps
securely, if the radiator hoses are swollen,
hardened or cracked.
NOTE :
• Replace the hoses and hose clamps every 4
years or earlier if they are found to be
swollen, hardened or cracked.
[LX3310]
(1) Radiator hoses (2 hoses)
(2)
Clamp bands (4 clamps)
[LX2610/LX2610SU]
(1) Radiator hoses (2 hoses)
(2)
Clamp bands (4 clamps)
2.1 Overheating countermeasures
Take the following actions in the event the coolant
temperature
is nearly at or over the boiling point, also
called “overheating”.
1. Park the tractor in a safe place and keep the engine
idling unloaded.
2. Don't stop the engine suddenly, but stop it after
about 5 minutes of unloaded idling.
3. Keep yourself well away from the machine for
further 10 minutes or while the steam blows out.
4. Check that there are no dangers such as burns. Get
rid of the causes of overheating according to the
troubleshooting section of this manual.
(See TROUBLESHOOTING on page 143.)
Afterward, restart the engine.
3. Checking fuel lines
1. Check
to see that all lines and hose clamps are
tight and not damaged.
2. If the hoses and clamps are found to be worn or
damaged, replace or repair them at once.
[LX3310]
(1) Fuel lines
(2)
Clamp bands
[LX2610/LX2610SU]
(1) Fuel lines
(2)
Clamp bands
NOTE :
• If
the fuel line has been replaced, be sure to
properly bleed the fuel system.
(See Bleeding fuel system on page 136.)
4. Checking intake air line
1. Check
to see that hoses and hose clamps are tight
and not damaged.
 PERIODIC SERVICE EVERY 1 YEAR
134
LX2610,LX3310

Table of Contents