Air-conditioner switch and indicator light
1. Push
the air-conditioner-switch to activate the air-
conditioner.
An indicator light will light up when the air-
conditioner-switch is set to on.
2. Push the air-conditioner-switch again to turn the air-
conditioner off, in which case the indicator light will
go off.
NOTE :
• The air-conditioner is operable only during
engine operation.
Temperature control lever
1. Set
the temperature-control-lever at the desired
position to obtain the desired air temperature.
• Move the temperature-control-lever to the right
to obtain cooler air.
• Move the temperature-control-lever to the left to
obtain warmer air.
Blower switch
The air flow (fan speed) equips three levels. At the [3]
position, you can obtain the largest air flow.
1. Set the blower switch at the desired position to
obtain the desired air flow (fan speed).
OPERATING THE CONTROL
P
ANEL
(1) Air-conditioner switch with
indicator light
(2) Temperature control lever
(3)
Blower switch
Heating air
1. Adjust
the blower switch [1], [2], and [3] and the
temperature-control-lever to achieve the desired
temperature level.
NOTE :
• In summer, when the heater is not used, keep
the temperature-control-lever at the cool
(rightmost) position. Otherwise, hot air will raise
the temperature in the cab.
Dehumidifying-heating
1.
Press and turn on the air-conditioner-switch.
2. Turn the blower switch on [1], [2], or [3].
3. Adjust
the temperature-control-lever to the cool
(rightmost) or an intermediate position to achieve
the desired temperature level.
NOTE :
• Be sure to close the door while the air-
conditioner is on.
Cooling
1.
Press and turn on the air-conditioner-switch.
2. Turn the blower switch on [1], [2], or [3].
3. Adjust the temperature-control-lever to the cool
(rightmost) or an intermediate position to achieve
the desired temperature level.
NOTE :
• Be sure to close the door while the air-
conditioner is on.
Defrosting or demisting
T
o defrost or demist the windshield, take the following
steps.
1. Open the front-air-outlet and direct it to the
windshield.
2. Set the blower switch to the [3] position and set the
temperature-control-lever to [warm] (leftmost)
position.
AIR CONDITIONER OPERATING THE CONTROL PANEL