Other Useful Information
Cleaning and care
WARNING!
• Before cleaning the espresso maker or removing parts, ensure it is
disconnected from the power supply and has cooled down completely.
• To avoid the risk of electric shock, do not clean the appliance with water
and do not immerse it in water.
• Do not use abrasives or harsh cleaning solutions.
Water container
• Remove the water tank and turn it upside down over a sink to discard any
water left inside. It is recommended to empty the water tank between uses
and before cleaning the appliance.
• Rinse the water container thoroughly before filling it with fresh water for use.
• Check the valve seals at the base of the water container regularly (Fig.12) and, if
necessary, carefully remove any dirt or lime deposits, which could cause leaks.
Steam wand, nozzle and frothing attachment
• Straight after the frothing process, wipe the steam wand and nozzle (and
frothing attachment, if it has been used) with a damp cloth.
• After use, pull the frothing attachment off the steam wand (Fig.13) and wash it
in warm, soapy water, rinse and dry.
• If the steam nozzle becomes blocked, proceed as follows:
• Pull the frothing attachment off the steam nozzle.
• Unscrew the nozzle from the steam wand, either with your hand or using the
measuring scoop as a tool.
• Insert a fine pin or needle into the steam nozzle to remove the blockage.
• Screw the steam nozzle back onto the wand.
• Push the frothing attachment back onto the nozzle.
Fig.13Fig.12
To Next Page
Loading...