Standard operating procedure (all models) 8
60
Normal spreading in/out of the headland tramlining
When continuing spreading in the field after spreading from the headland tram-
line, please note the following:
Move the border spreading unit TELIMAT out of the spreading area.
Figure 8.19: Normal spreading
[A] End of spreading fan during spreading in the headland tramline
[E] End of spreading fan during spreading on the field
[T] Headland tramline
[X] Working width
The metering slides should be closed or open according to the various distances
travelled to and back from the headland field boundary.
Driving out of the headland tramline
Open the metering when the following condition is fulfilled:
-
The end of the spreading fan on the field [E] is approximatively at a distance
of half the working width + 4 to 8 m from the headland field boundary.
The tractor is then located at different distances in the field, depending on the
spreading width of the fertiliser.
Driving into the headland tramline
Close the metering slides as late as possible.
- The end of the spreading fan should ideally come to lie on the field [A] at
a distance of app. 4 to 8 m further than the working width [X] of the head-
land.
- This is not always possible, depending on the casting distance of the ma-
terial and the working width.
Alternatively, you can either drive out of the headland tramline or a second
headland tramline can be laid down.
Follow these directions for an environmentally friendly and economical method of
working.
To Next Page
