Why is soil building up in front of the cutterbar on my KUHN Lawn Mower?
Soil build up in front of the cutterbar on your KUHN Lawn Mower can be attributed to too much cutterbar down pressure. To resolve this, increase the accumulator pressure. Very wet working conditions can also lead to this issue, so increasing the accumulator pressure is also recommended in these conditions.
Why is there uneven stubble when using my KUHN FC283 R?
Uneven stubble when using the KUHN Lawn Mower can be caused by several factors. It may be due to dull or broken knives, which requires you to replace the knives. Another cause could be knives not installed correctly; ensure the arrow on the knife upper face is pointing in the disc's direction of rotation. Lastly, too low PTO speed (rotational frequency) can be the culprit, so increase the speed to 1000 min-1.
How to fix badly shaped windrows with KUHN Lawn Mower?
Badly shaped windrows when using the KUHN Lawn Mower can occur if the PTO speed (rotational frequency) is too low; increase the speed to 1000 min-1. Additionally, incorrectly adjusted swath shields can cause this issue, so adjust both swath shields.
What to do if my KUHN FC283 R Lawn Mower has bad ground contour adaptation?
If your KUHN Lawn Mower has bad ground contour adaptation, it could be due to several reasons. The main frame setting might be incorrect; adjust the main frame height with regards to the ground. Excessive ground speed can also cause this, so reduce ground speed. Insufficient ground pressure may be another factor; reduce accumulator pressure to resolve this.
Why are the leaves and stems damaged when using my KUHN FC283 R?
If leaves and stems are damaged when using your KUHN Lawn Mower, it could be due to issues with the roller parallelism and gap; adjust the parallelism and play between rollers. Alternatively, the conditioning may be too intense, so adjust the conditioning intensity.
How to reduce considerable vibrations in KUHN FC283 R Lawn Mower?
Considerable vibrations in your KUHN Lawn Mower can be caused by issues with the roller parallelism and gap. Adjust the parallelism and play between the rollers to reduce these vibrations.
What causes excessive lateral oscillation in transport position of my KUHN Lawn Mower's mowing-conditioning unit?
Excessive mowing-conditioning unit lateral oscillation in transport position on your KUHN Lawn Mower can be caused by an incorrect transport stop adjustment. Readjust the transport stop to correct this issue.
Essential guidelines for safe operation and maintenance of the machine.
Guidelines for safe operation, pre-checks, and driving.
Lists technical data like working width, weight, power requirements, and speeds.
Procedures for setting up controls, coupling, and connecting PTO/hydraulics.
Procedures for adjusting cutting height and ground pressure.
General| Brand | KUHN |
|---|---|
| Model | FC283 R |
| Category | Lawn Mower |
| Language | English |
To Next Page
