KUHN FC302G - User Manual

Questions and Answers

M
melissa88Aug 3, 2025
How to fix uneven stubble with my KUHN Lawn Mower?
- J
  johnsontimothyAug 3, 2025
  Uneven stubble can occur for several reasons. Check for dull or broken knives and replace them if needed. Ensure knives are installed correctly, with the arrow on the knife's upper face pointing in the disc's direction of rotation. Reduce ground speed if it's excessive. Adjust the cutting height and mowing unit ground pressure. If you are mowing tangled or down crops, reduce the cutting height and increase the mowing unit ground pressure. For very wet conditions, adjust both the mowing unit ground pressure and the cutting height.
R
robertrosarioAug 7, 2025
Why does my KUHN Lawn Mower have frequent knife breakage?
- K
  Kimberly HarrisAug 7, 2025
  Frequent knife breakage can be attributed to a few factors. Check and adjust the cutting height if it's incorrect. Also, too much cutterbar down pressure can cause this issue, so adjust the mowing unit ground pressure. Finally, excessive ground speed can lead to knife breakage, so reduce your ground speed.
W
William RamirezAug 11, 2025
What to do if my KUHN Lawn Mower is creating badly shaped windrows?
- S
  sjohnsonAug 12, 2025
  Badly shaped windrows can result from several issues. Slipping belts can be a cause, so retension them. Insufficient PTO speed can also contribute; increase the PTO speed and ensure it matches the tractor's nominal speed. Incorrectly adjusted swath shields can also be the culprit, so adjust both of them.
N
nicole75Aug 15, 2025
How to prevent soil build up in front of the cutterbar on my KUHN Lawn Mower?
- L
  Lisa RhodesAug 15, 2025
  Soil build-up in front of the cutterbar can occur if there's too much cutterbar down pressure; adjust the mowing unit ground pressure. Very wet working conditions can also contribute, so adjust both the mowing unit ground pressure and the cutting height.
A
Anthony OconnorAug 20, 2025
Why is there an obstruction of conditioning rotor in my KUHN Lawn Mower?
- J
  Jeremy LopezAug 20, 2025
  An obstructed conditioning rotor may be due to several factors. Check that the rotor drive belts are correctly tensioned, as insufficient rotor speed can cause obstructions. Too low PTO speed can also be a factor; increase the PTO speed and ensure it corresponds to the tractor's nominal speed. Also, check if the swath shields are too closed and open them if necessary. Finally, inspect the belts for wear or stretching; tighten or replace them as needed.
J
Jennifer DavisAug 25, 2025
Why does my KUHN FC302G require too much pull power?
- D
  Donna GonzalezAug 25, 2025
  If your machine requires too much pull power, it could be due to excessive cutterbar down pressure. Adjust the mowing unit ground pressure to resolve this.
M
Michael FrankAug 28, 2025
Why are leaves and stems damaged when using my KUHN FC302G Lawn Mower?
- V
  vkingAug 28, 2025
  Damage to leaves and stems often indicates that the conditioning is too intense. Adjust the conditioning intensity to reduce the damage.