KUHN FC302G - Preparing the Machine

FC302G - FC302GI - FC352G
34
6. - Putting into service
KN270BGB_F
Mower conditioner
6.2.3 Preparing the machine
 Changing the PTO speed
With the machine attached:
The machine is factory set at a PTO speed of
1000 rpm.
- Attach lower links to the hitch pins on the inside of
the yokes.
- Uncouple the primary pto shaft from the tractor's
PTO stub.
- Lower and lock parking stand (1).
- Raise tractor lift linkage to free parking stand.
- Remove pin (2).
- Remove pin (3).
- Pivot lower gearcase (4) by half a turn.
- Reinstall pin (3).
- Reinsert pin (2).
- Reinstall drive shaft guard (5).
- Couple PTO shaft on machine side.
4
1
5
3
2
The input machine speed (rotational
frequency) must correspond to the tractor
PTO speed.
Follow the same procedure to switch from 540 to
1000 rpm.