Mower conditioner
90
FC883RA
Maintenance and storage
Inspection of knives and securing elements
Knives
Inspect systematically all knives before the machine is
operated to:
• guarantee the cutting quality.
• guarantee safety in use.
• Prevent cutterbar damage risks.
Replace knives in the following cases:
- Damaged knives.
• Very rough conditions can cause knives to crack
and become deformed.
- Worn knives.
Knife length C must exceed 65 mm (2.6’’).
Knife width B, measured at a distance A of 10 mm (0.4’’)
from the disc edge must exceed 20 mm (0.8’’).
The hole L for the securing bolt must not become oval by
more than 20 mm (0.8’’).
Always replace both knives per disc to avoid creating an
out-of-balance force.
Immediately replace worn or damaged parts with
genuine KUHN parts.
To Next Page
Loading...