KUPPET HZB-45 - Exterior Cleaning; Interior Cleaning; Ice Making Parts Cleaning

17
What shouldn't be done
Never keep anything in the ice storage bin that is not ice: objects like wine and beer bottles are not only
unsanitary, but also it’s labels may slip off and obstruct the drain pipe.
Exterior Cleaning
The door and cabinet may be cleaned with a mild detergent and warm water solution such as 28g of
dish washing liquid mixed with 7.5L of warm water. Do no t use solvent-based or abrasive cleaners. Use
a soft sponge and rinse with clean water. Wipe with a soft clean towel to prevent water spotting.
Stainless steel models can disc olor when exposed to chlorine gas and should be cleaned. Clean
stainless steel model s with a mild detergent and warm water solution an d a damp cloth. Never use
abrasive cleaning agents.
NOTICE: Stainless steel models exposed to chlorine gas and moisture, such as in a re as
with spas or swimming pools, may have some discoloration of sta inless steel.
Discoloration from chlorine gas is normal.
Interior Cleaning
For Ice Storage Bin
The ice storage bin should be sanitized occasionally. Clean the bin before the ice maker is used for the
first time and reused after stopp ing for an extended period of time. It is usually convenient to sanitize
the bin after the ice making system has been cleaned, and the storage bin is empty.
1. Disconnect power to the unit.
2. Open the door and with a clean cloth, wipe down the interior with a sanitizing s olution made of
28g of househol d bleach or chlorine and 7.5L of hot water (95
℉
t
o
155
℉
).
3. Rinse thoroughly with clear water. The waste water will be drained out through the drain pipe.
4. Reconnect po wer to the unit.
The ice scoop should be washed reg ularly. Wash it just like any other food container.
Ice Making Parts Cleaning
During the using, periodically to clean these main system of your ice -maker.
1
、
Repeat above step to clean the water tank and other inner pa rts of the unit.
2、 Especially, to the water dividing pipe on the evaporator, when the compressor and the water pump
run normally, but if there is no water flowing out from the wat er dividing pipe or the water flowing is
very small, please discharge this water dividing pipe to clean c arefully. Clean each little holes on
the water dividi ng pipe displayed in the following illustration, make sure each hole is not clogged by
something, then install back to the original location .