Basic Effects Mode
Terminology
9-3
FXBus (also called Insert FXBus)
A signal path with some kind of processing Ña delay, reverb, ßanger, etc.Ñon it. It has stereo
inputs and outputs, and contains an FX preset that determines the kind of processing to be
applied. A studio has four insert FXBuses, each with its own FX preset, as well as a Þfth FXBus,
known as the Aux bus.
Aux FX Bus (Aux Bus)
A separate bus from the insert FXBuses, which is placed in the signal path after the output of the
insert FXBuses, so that it can act as a global processor.
FX Preset
Determines the type of signal processing that is present on an FXBus or the Aux Bus. FX presets
consist of an algorithm, plus the settings of the parameters associated with that algorithm. Any
number of FX presets can use the same algorithm. The K2600 comes with a large number of
FX presets, and you can modify them or create new ones and store them in RAM. Algorithms,
however, are stored in ROM, so you canÕt change them. Each FXBus and the Aux Bus gets its
own FX preset, so up to Þve FX presets can be active in a studio at a time.
Algorithm
A speciÞc type of signal processing, like a hall reverb, plate reverb, chorus, ßanger, pitcher,
compressor, or rotary speaker, which is at the core of an FX preset. KDFX comes with a large
variety of algorithms, which are stored in ROM, and are not user-deÞnable. Additional
algorithms, supplied by Kurzweil, can be loaded in from disk when they become available.
Algorithm parameters (RT
60
, delay feedback, pitch change, etc.)
are
user-deÞnable; the K2600
stores the values of those parameters in RAM as part of an FX preset.
Size/PAUs
How big an algorithm is, in terms of how much processing power it needs to operate. Size is
measured in Processor Allocation Units, or PAUs. The simplest algorithms require only 1 PAU,
while more complex ones require 2, 3, or even 4. The total number of PAUs available to the four
insert FXBuses is 4. PAUs can be allocated automatically as FX presets are assigned to FXBuses,
or manually by the user. The Aux Bus has its own set of 3 PAUs, which are not shared with the
insert FXBuses.
Parameters
Refers to the user-controlled settings for the different characteristics of an algorithm. For
example, the user can set the reverb time (RT
60
) of an algorithm to
3.5s
, or the delay feedback of
a delay line to
90%
, or the dynamic ratio of a compressor to
10:1
. Parameters are stored, along
with the algorithm they modify, as part of an FX preset. In certain cases, the parameter settings
within a studio can be overridden, either using FXMods or bus overrides.
To Next Page
Loading...
Need help?
General
