9-12
Basic Effects Mode
A Tour of Effects Mode
A Tour of Effects Mode
LetÕs take a tour through several studios. After you do this, you should have a pretty good idea
of what itÕs like to work with Effects mode. You will still, of course, have many questionsÑ
answering them is the job of the rest of this manual.
Load the Tutorial files
From the K2600 Demos disk that came with your K2600, load the Þle KDFXTUTR.K26 into
bank 200...299. You can use a different bank if you like, but then your numbers and the ones in
this chapter will be different.
1. Insert the disk into the drive
2. Press Disk to go into Disk mode
3. Set Current Disk to Floppy
4. Press Load
5. Cursor down to KDFXTUTR.K26
6. Press OK
7. In the ÒLoad this Þle as:Ó dialog, select 200...299
8. Press OK
9. Press OverWrt (this will erase all objects in the 200s bank, so you should save anything
you want to keep before doing this; press Cancel if you want to save objects before
proceeding).
10. Press Exit to get back to Program mode.
A Simple Studio
Call up Program #199 on your K2600. In Program mode, either scroll the Alpha wheel to
Program 199 (Default Program), or press 1-9-9-Enter on the Alphanumeric pad.
Now go into Effects mode by pressing the Effects button, and youÕll see this page:
If the page looks very different from this, then put the cursor on the FX Mode parameter and
scroll the Alpha wheel until it says Master. Now use the Down cursor button to highlight the
Studio parameter. Scroll the Alpha wheel until the Studio parameterÕs value is 200 Simple.
EffectsMode|||Xpose:0ST|||||<>Channel:1|
Studio|:199|Default|Studio||
Wet/Dry:0%Wet
FX|Mode:Master
FX|Chan:None
Dither|:Flat||||||||DigOut|:16|Bit
Octav-|Octav+|Panic|||||||||Chan-||Chan+
Effect|:1|Sweet|Hall
To Next Page
Loading...
Need help?
General
