Kurzweil M90 - Managing Song Tracks; Selecting Tracks and Clearing Data; Playing Back Recorded Tracks

35 36
Manually Select a Track to Record:
Press the [Record] button to enter Record Wait Mode.
Turn the Data Control knob to select between Only Track 1, Only Track 2,Track 1, Track 2 .
The display will show
You will also see options for “Clear 1 ”(abbreviated “cl1 ”)and “Clear 2” (abbreviated “cl2” ),
which you can ignore for the moment. These will be discussed later in this section.
In this case, you can record the song in Track 1, if the Track 2 has data, it will not play.
In this case, you can record the song in Track 2, if the Track 1 has data, it will not play.
In this case, you can record the song in Track 1, if the Track 2has data, it will play automatically.
In this case, you can record the song in Track 2, if the Track 1 has data, it will play automatically.
In this case, you can clear the record data of Track 1.
In this case, you can clear the record data of Track 2.
When the LED display shows the track you wish to record to, you may begin playing
whenever you are ready, and recording will automatically begin as soon as you play the
rst note.
Clearing a Single Track in the Song Recorder:
Press the [Record] button enter Song Recording Mode.
Use the [Data Control] knob to select the track you wish to clear.
Press the [Record] button, the track will be erased, and this piano will be back in
Performance Mode.
The LED will then display the currently selected Voice
Playing Back Your Song Recorder Tracks:
Press the [Record] button and the [Demo/Learn] button at the same time to enter Song
Play Mode.
Song Recording