13-14
Tutorials: Setup Mode
Assigning Multiple Knobs To Control Volume In Different Zones
4. On the Controllers page, Zone 1 will be selected. You can view the number of the selected Zone in
the top right corner of screen (see below.) If you are not on Zone 1, use the Chan/Zone buttons to
the left of the display to select Zone 1.
5. On the Controllers page, the Controller field will be highlighted (if not, select the Controller field
with the cursor buttons.) Make sure the LED to the left of Timbre Knob is lit, if it is not, press
the Shift button to the left of the Knobs until that LED is lit. Next, hold the Enter button on the
alphanumeric pad and move the Knob labeled Timbre. This will select Knob 1 for the Controller
field (see below.) You can also set the desired controller in the Controller field by using the Alpha
Wheel or - / + buttons.
6. With Knob 1 selected in the Controller field, use the cursor buttons to select the DestType field and
then use the Alpha Wheel or - / + buttons to select Ctrl (see below.)
To Next Page
Loading...
