13-34
Tutorials: Setup Mode
Assigning a Footswitch to Switch From One Setup To Another
2. With the setup 28 World selected in setup mode, press the Edit button on the front panel. This will
bring you to the CH/PROG page of the setup editor (see below.)
3. From the CH/PROG page, press the CTRLS soft button on the bottom of the screen (see above.)
This brings you to the Controllers page where you can view and assign physical controllers to
destinations for the current Zone.
4. On the Controllers page, Zone 1 will be selected. If not use the Chan/Zone buttons to the left of the
display to select Zone 1. You can view the number of the selected Zone in the top right corner of
screen (see below.)
5. On the Controllers page for Zone 1, the Controller field will be highlighted (if not, select the
Controller field with the cursor buttons.) Make sure that you have switch pedal plugged into the
SW2 pedal jack on the back panel of the PC3LE. Next, hold the Enter button on the alphanumeric
pad and step on that switch pedal. This will select SW Pedal 2 for the Controller field (see below.)
You can also set the desired controller in the Controller field by using the Alpha Wheel or - / +
buttons.
To Next Page
Loading...
