Tutorials: Setup Mode
Assigning a Footswitch to Switch From One Setup To Another
13-35
6. With SW Pedal 2 selected in the Controller field, use the cursor buttons to select the DestType field
and then use the Alpha Wheel or - / + buttons to select Ctrl (see below.)
7. With Ctrl selected in the DestType field, use the cursor buttons to select the OnControl field. In
the OnControl field, press 139 and then the Enter button on the alphanumeric pad to choose
SetupInc (see below.) You can also use the Alpha Wheel or - / + buttons to select a destination in
the OnControl field.
Important: Once you assign your switch pedal to SetupInc, make sure you don’t step on it until
you’ve exited the Setup Editor. If you step on the pedal while you are in the Setup Editor, all of
the settings of your setup will change to the settings of the next Setup in the Setups list, and you
will lose any changes that you have not yet saved for the current setup. There is no way to undo
this, if this happens you should exit the Setup Editor without saving and re-do your edits to the
Setup.
8. Next, use the cursor buttons to select the OffControl field. In the OffControl field, press 0 and
then the Enter button on the alphanumeric pad to choose OFF (see below.) The other fields on this
page should be left at their defaults (Type: Momentary, OnValue: 127, OffValue: 0, EntryState:
None, ExitState: None.)
To Next Page
Loading...
