Program Mode
V.A.S.T. and KB3 Programs
6-7
You can also change the programmed settings for the KB3-mode buttons to perform non-KB3
functions, such as controlling an Aux effect, by changing the settings on the Program Editor
Parameters page.
Additional Controller Assignments In KB3 Mode
Other default assignments for factory KB3 programs include:
Knob 10 and CC Pedal 1 control the Swell (volume pedal) parameter.
Knob 11 controls the Leakage parameter, which controls the level of simulated signal “bleed” of
adjacent tone wheels. Generally, turning up the leakage parameter creates a “dirtier” organ
sound. This can be used for emulating different aged organs, as an older organ will have more
leakage as it ages and its capacitors begin to leak.
The Mod Wheel controls Distortion Drive.
Switch Pedal 1 (the sustain pedal) controls the Rotary FootSw parameter, which toggles the
Rotary speed between slow or fast.
Switch #
Effect
Category
Button Name
Corresponding
Parameter
Comments
1 Rotary Slow/Fast Rotary Slow/Fast
2 Rotary Brake Rotary Brake
3
Vibrato
On / Off Chorus/Vibrato On/Off
4 Chorus / Vibrato Chorus/Vibrato Select Disabled if Switch 3 is off
5 Depth 1 / 3 Chorus/Vibrato Depth Disabled if Switch 3 is off
6 (row 2)
Percussion
On / Off Percussion On/Off
7 (row 2) Volume Loud / Soft Percussion Level Disabled if Switch 6 is off
8 (row 2) Decay Fast / Slow Percussion Decay Disabled if Switch 6 is off
9 (row 2) Pitch High / Low Percussion Pitch Disabled if Switch 6 is off
10 (row 2)
Click
On / Off KeyClick On/Off
To Next Page
Loading...
