1716 Kuvings Hands-Free Slow Juicer AUTO10
SILICONE PARTS
HOW TO CLEAN SILICONE PARTS
• Silicone parts can be separated and assembled.
• The silicone parts should be dried after washed and stored.
• Make sure that the silicone parts are properly inserted before assembling.
* If the silicone part is not completely inserted, the amount of undiluted juice
solution may be less, or the undiluted solution may flow out.
Pull the silicone brush from the rotary wiper to
separate it and wash it.
* After washing, insert the silicone brush with
the tail of the brush facing down in order of
“from bottom to top” through the wide part in
the middle of the wiper.
Silicone Brush
Remove the smart cap silicone from the smart
cap and wash it.
* After washing, insert silicone into the smart cap
before use.
Smart Cap Silicone
Remove the silicone ring from the juicing bowl
to clean. After cleaning, push in the silicone
ring with the smaller surface facing down.
Silicone Ring
Pull the silicone from the drum and wash it.
The pulp outlet silicone is connected to the
drum and cannot be separated completely.
After washing, Insert the silicone completely
into the groove.
If the silicone part is not completely inserted,
the amount of undiluted solution may ow out.
Pulp outlet silicone
QUICK RINSING
Close the smart cap.
01
Open the smart cap and let the water run
out of the drum.
03
Pour water through the auto hopper hole
and operate for 30 seconds.
02
It is possible to juicing ingredients one after another after simple washing. After all juicing is
completed The top set must be separated and washed fully.
NOTE
CAUTION
To Next Page
Loading...
Need help?
General
Weight and Dimensions
