Kverneland NGS 301 - User Manual

Questions and Answers

I
ihernandezAug 7, 2025
Why is my Kverneland NGS 301 Farm Equipment gearbox overheating?
- D
  Diane GarnerAug 7, 2025
  Gearbox overheating in Kverneland Farm Equipment can occur due to several reasons. It might be caused by a low gearbox oil level, potentially due to damaged seals and gaskets that need replacement; using the incorrect type of oil, which requires changing to the prescribed type; having excessive oil, which means you should restore the correct oil level; or experiencing an overload, so you should observe the prescribed speed and power conditions.
P
Peter McdanielAug 12, 2025
What to do if Kverneland NGS 301 Farm Equipment drive shaft is wearing?
- G
  Gerald Knight DVMAug 12, 2025
  If your Kverneland Farm Equipment drive shaft is experiencing wear, it could be due to insufficient lubrication, in which case you should apply grease as indicated by the drive shaft manufacturer. Another cause might be an incorrect operating angle, suggesting that you should reduce the operating angle. Overload can also cause drive shaft wear, so avoid overloading the shaft and starting the machine under load.
P
Patricia LeeAug 17, 2025
How to fix a noisy Kverneland NGS 301 drive shaft?
- J
  Justin RoseAug 17, 2025
  Noise from the drive shaft in Kverneland Farm Equipment can often be attributed to a few key issues. Insufficient lubrication is a common cause, so apply grease as indicated by the drive shaft manufacturer. Worn trunnion bearings can also generate noise, suggesting the need to renew the bearings. Finally, if the drive shaft length is incorrect, adjust the length, replacing any components cut to the wrong length where necessary.
R
Rachel TaylorAug 22, 2025
What to do if Kverneland NGS 301 Farm Equipment drive shaft breaks or deforms?
- T
  timothy67Aug 22, 2025
  If the drive shaft of your Kverneland Farm Equipment breaks or deforms, the cause is likely overload. To address this, avoid overloading the shaft and starting the machine under load, and check the operation of the torque limiter.
S
Sharon WatersAug 27, 2025
What causes oil leaking from tine holders in Kverneland NGS 301?
- K
  Kevin BellAug 27, 2025
  Oil leaking from the tine holders in Kverneland Farm Equipment is typically caused by damaged seals due to foreign material. The solution is to renew the damaged seals.
R
Ricky HardySep 2, 2025
Why is soil accumulating at the sides of my Kverneland NGS 301 Farm Equipment?
- M
  morganjimmySep 2, 2025
  The accumulation of soil at the sides of your Kverneland Farm Equipment is likely due to bent stone guards. You should straighten or renew the damaged parts.