Kverneland NGH 301 - User Manual

Questions and Answers

C
Christopher SellersAug 2, 2025
Why is my Kverneland Farm Equipment gearbox overheating?
- A
  Alexander GarciaAug 2, 2025
  Gearbox overheating in Kverneland Farm Equipment can occur due to several reasons. It might be caused by a low gearbox oil level, potentially due to damaged seals and gaskets that need replacement; using the incorrect type of oil, which requires changing to the prescribed type; having excessive oil, which means you should restore the correct oil level; or experiencing an overload, so you should observe the prescribed speed and power conditions.
J
James Erickson IIIAug 7, 2025
What to do if Kverneland Farm Equipment drive shaft is wearing?
- M
  Michael LoveAug 7, 2025
  If your Kverneland Farm Equipment drive shaft is experiencing wear, it could be due to insufficient lubrication, in which case you should apply grease as indicated by the drive shaft manufacturer. Another cause might be an incorrect operating angle, suggesting that you should reduce the operating angle. Overload can also cause drive shaft wear, so avoid overloading the shaft and starting the machine under load.
H
Hailey FrankAug 12, 2025
How to fix a noisy Kverneland Farm Equipment drive shaft?
- S
  Sean RiosAug 12, 2025
  Noise from the drive shaft in Kverneland Farm Equipment can often be attributed to a few key issues. Insufficient lubrication is a common cause, so apply grease as indicated by the drive shaft manufacturer. Worn trunnion bearings can also generate noise, suggesting the need to renew the bearings. Finally, if the drive shaft length is incorrect, adjust the length, replacing any components cut to the wrong length where necessary.
C
Carla WagnerAug 17, 2025
What to do if Kverneland NGH 301 drive shaft breaks or deforms?
- M
  Matthew RamirezAug 17, 2025
  If the drive shaft of your Kverneland Farm Equipment breaks or deforms, the cause is likely overload. To address this, avoid overloading the shaft and starting the machine under load, and check the operation of the torque limiter.
C
Christian CastroAug 22, 2025
What causes oil leaking from tine holders in Kverneland NGH 301?
- H
  Heather BernardAug 22, 2025
  Oil leaking from the tine holders in Kverneland Farm Equipment is typically caused by damaged seals due to foreign material. The solution is to renew the damaged seals.
J
Jamie WatersAug 27, 2025
Why is soil accumulating at the sides of my Kverneland NGH 301 Farm Equipment?
- W
  William WagnerAug 27, 2025
  The accumulation of soil at the sides of your Kverneland Farm Equipment is likely due to bent stone guards. You should straighten or renew the damaged parts.