Kverneland NGS 401 - User Manual

Questions and Answers

G
glewisAug 7, 2025
Why is my Kverneland NGS 401 Farm Equipment gearbox overheating?
- L
  latoyareyesAug 7, 2025
  Gearbox overheating in Kverneland Farm Equipment can occur due to several reasons. It might be caused by a low gearbox oil level, potentially due to damaged seals and gaskets that need replacement; using the incorrect type of oil, which requires changing to the prescribed type; having excessive oil, which means you should restore the correct oil level; or experiencing an overload, so you should observe the prescribed speed and power conditions.
P
Phillip RobertsAug 12, 2025
What to do if Kverneland Farm Equipment drive shaft is wearing?
- J
  jennifer11Aug 12, 2025
  If your Kverneland Farm Equipment drive shaft is experiencing wear, it could be due to insufficient lubrication, in which case you should apply grease as indicated by the drive shaft manufacturer. Another cause might be an incorrect operating angle, suggesting that you should reduce the operating angle. Overload can also cause drive shaft wear, so avoid overloading the shaft and starting the machine under load.
T
tharrisAug 17, 2025
How to fix a noisy Kverneland NGS 401 drive shaft?
- D
  David FrancoAug 17, 2025
  Noise from the drive shaft in Kverneland Farm Equipment can often be attributed to a few key issues. Insufficient lubrication is a common cause, so apply grease as indicated by the drive shaft manufacturer. Worn trunnion bearings can also generate noise, suggesting the need to renew the bearings. Finally, if the drive shaft length is incorrect, adjust the length, replacing any components cut to the wrong length where necessary.
R
Robert MooreAug 22, 2025
What to do if Kverneland Farm Equipment drive shaft breaks or deforms?
- C
  Christie LongAug 22, 2025
  If the drive shaft of your Kverneland Farm Equipment breaks or deforms, the cause is likely overload. To address this, avoid overloading the shaft and starting the machine under load, and check the operation of the torque limiter.
F
Frank MccormickAug 27, 2025
What causes oil leaking from tine holders in Kverneland NGS 401?
- A
  Amanda ThompsonAug 27, 2025
  Oil leaking from the tine holders in Kverneland Farm Equipment is typically caused by damaged seals due to foreign material. The solution is to renew the damaged seals.
S
stanleymariaSep 1, 2025
Why is soil accumulating at the sides of my Kverneland NGS 401?
- A
  Andrea BrownSep 2, 2025
  The accumulation of soil at the sides of your Kverneland Farm Equipment is likely due to bent stone guards. You should straighten or renew the damaged parts.