SECTION III
Adjustments
P 3.8
086A 08 08
N. CAM SWITCH MOUNTING:
The cam switch allows the cam assembly to rotate
and only stop when a closure reaches the bag
closing position. The switch cam on the cam
assembly (Figure 3.13) actuates the switch. If the
rocker switch is in the “RUN” position, the “READY”
light will be on while the cam switch is actuated.
The cam switch should not need adjustment.
O. MOTOR ROTATION:
Inadvertently rotating the motor shaft manually can
damage the cam switch (Figure 3.14). If the motor
is to be manually rotated ONLY ROTATE THE
MOTOR CLOCKWISE FROM THE FAN END OF
THE MOTOR. If the motor shaft is turned in the
opposite direction (counterclockwise from the fan
end of the motor) the cam switch will likely be
damaged.
Figure 3.14
Figure 3.13
To Next Page
Loading...