- 5 -
Part II Installation & Application
2.1 Transportation
When transporting the heat pump, ensure that it keeps upwards and not tilted more than 45°in any direction.
2.2 Installation Location Selection
It is very important to select a proper position for the unit, you should consider the followings:
● The ventilation of the heat pump should be in good condition.
● The installation position should be close to drainage channel to facilitate condensate water discharge.
● Choose a smooth, horizontal position where it can stand the weight of the unit, and it won’t increase
noise and vibration as well,
● Do not install the unit in place where there is pollution, accumulation of dirt or fallen leaves.
● There should not be inflammable or explosive materials close to the unit.
Note:
1. Make sure to install a wye strainer before water inlet of the unit to avoid clogging of the system. It’s an
essential requirement to install a relief valve onto the water tank.
2. Install mixing valve in user’s hot water system to increase the utilization rate of hot water.
Remark: The heat pump must be fixed to avoid topple.
To Next Page
