KYMCO Agility - Scooter Braking and Protection; Using the Brakes; Overload Protection

OPERATING THE SCOOTER
25
6. Check before you power on the scooter:
Ensure your scooter is in
drive mode (not in
“freewheel” mode)
Check the “freewheel”
mode lever is in the
pushed down position
Seat is locked into the
desirable position
Move the seat forwards
and backwards to ensure
it is stationary.
Are the batteries charged?
Check the dashboard to
verify the charging status
of the batteries
Are the brakes working?
Check by driving slowly
and stopping again
Are the tires and wheels
undamaged and is the air
pressure correct?
Visual check of tires and
wheels
8.1 POWERING ON/OFF
The switch is located near the right side
of the dashboard.
Insert the key into the switch and turn it
to the right to power on the scooter.
Turn it to the left to power off the
scooter.
8.2 LCD PANEL
LCD panel “On”:
The scooter is switched on and ready for driving.
If the Operation
indicator is
blinking:
There may be a
faulty situation.
Please switch off
the scooter and
contact your
approved service
provider.