OPERATING THE SCOOTER
Use your left index and middle fingers to pull the left
side of the lever to move backwards.
= driving backwards
Do not pull both sides of the throttle control lever
simultaneously.
8.4 OVERLOAD PROTECTION
The overload protection switches the power off when the
motor becomes overloaded while trying to climb over
too high an obstacle, such as a curb or trying to climb
too steep of an incline.
If the motor is overloaded, the following happens:
• The scooter becomes noticeably slower and then stops
• The control system shuts down the scooter
To rectify this:
Switch the scooter off and allow it to cool down for a
few minutes.
Switch the scooter on and reverse away from the
obstacle (such as a curb) and then avoid the obstacle.
8.5 SWITCHING ON THE FRONT/REAR
POSITION LIGHT
Front /Rear
Position light button:
Switch on = press button once
Switch off = press button again
A switch indicator will light up to
show that the Front /Rear Position
light are switched on.
If you drive with the Front /Rear Position light on,
the batteries will drain faster and the scooter
driving range will be slightly reduced.
8.6 SWITCHING ON THE
HORN
Press the horn button.
It will sound for as long as you hold
the button down.
25
To Next Page
Loading...
Need help?
General
