KYMCO Mini LS - Page 35

BATTERY AND CHARGING THE BATTERY
Flash
code
Possible solution
6
The controller is
being inhibited
from driving.
Check the battery charger
connector.
Remove the battery
charger from the scooter.
7
A speed control
lever fault is
indicated.
Make sure that the speed
control lever is in the rest
position before switching
on the scooter.
8
A controller fault is
indicated.
Make sure that all
connections are secure.
9
The parking brakes
have a bad
connection.
Check the parking brake
and motor connections.
Make sure the controller
connections are secure.
10
Excessive voltage
has been applied to
the controller.
Check the battery
connections. This is usually
caused by a poor battery
connection.
If your meter diagnostic light shows any of the above
signals, please contact your approved service provider!
32