KYMCO PEOPLE S 200 Service Manual

2. EXHAUST MUFFLER/FRAME COVERS
2-4
PEOPLE S 4T
FLOOR-FOOT REMOVAL
Remove the screws attaching the right and
left side covers.
Remove the right and left side covers by
pulling them outward.
Disconnect the battery wire.
Remove the battery.
Remove the floor mat.
Remove the center cover. (
Ö
2-3)
Remove the screws and bolts attaching the
front right and left side covers.
Remove the five bolts attaching the floor-foot.
Remove the floor-foot.
The installation sequence is the reverse of
removal.
LEG SHIELD LOW REMOVAL
Remove the met-in box.
Remove the body cover.
Remove the floor-foot.
Remove the front upper cover.
Remove the four screws attaching the leg
shield low.
Disconnect the leg shield low with the cowl
under cover.
The installation sequence is the reverse of
removal.
Screws
Side Cove
r
Battery Wire
Floo
r
-Foot
Screws
Battery
Bolts
Leg Shield Low
Cowl Under Cove
r
Screw

KYMCO PEOPLE S 200 Specifications

General

Displacement	163 cc
Cooling System	Air-cooled
Fuel System	Carburetor
Ignition	CDI
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Drum
Front Tire	110/70-16
Rear Tire	120/80-16
Seat Height	800 mm
Fuel Capacity	7.5 liters
Engine Type	4-stroke
Transmission	CVT
Width	730 mm
Rear Suspension	Dual shock absorbers
Max Power	11.5 hp