3-58
Enhancement device setup procedure > Optional device installation
[CONFIDENTIAL]
<C> Bridge kit for paper feeder (AK-9130) to Paper feeder (PF-9100)
Preparation for Horizontal Transport Unit into downstream Paper feeder (PF-9100)
• Up to 2 units of paper feeder PF-9100 can be connected by installing a bridge kit for paper feeder AK-9130
between them.
• In this manual, PF-9100 that is closer to main unit, is defined as 1st or downstream unit and further from main
unit is 2nd or upstream unit.
• See Bridge Kit for Paper Feeder (AK-9130)
for unpacking.
• Make sure that the main power switch and AC power switch of the main machine are turned OFF and that its
power cord is disconnected before doing the following procedure.
• Attaching position of the four units
• [A]: Detent unit
• [B]: Entrance motor unit
• [C]: Exit motor unit
• [D]: Control board
To Next Page
Loading...
