5-6
Corrective action when service call occur > C2120
[CONFIDENTIAL]
14
When turning the print conveying lift motor, please make sure not to touch the print
head nor the print conveying belt. (Screw x2)
(Use the stubby driver to remove the screws since it is narrow.)
15
Hold the handles [B] and [C] then re-install the image conveying unit [A].
• Take care not to damage the electrical components.
4 pins [C] on rails have to align with 4 holes [A] and [B] in the frame of the image conveying unit. (Pay attention
the alignment otherwise the unit may drop.)
And also, if the frame goes over the pin, the unit becomes incline and service call error C2700 occurs. Make
sure to check the pin position again.
To Next Page
Loading...
