6-35
Machine transportation after setup > Procedure for the main unit transportation (Truck transportation)
[CONFIDENTIAL]
14
Remove the left side bracket [B] from the image conveying unit [A]. (Screw x8)
15
Remove the upper left cover [A]. (Screw x11)
16
Remove the screw of the cap front plate [A]. (Screw x1)
If you fail to remove the transport brackets, reverse winding error comes up as lift wire gets lose the unit can not
drive downward from the removal position after power on.
C2740: Conveying belt lower limit sensor error, C2750: Conveying belt wire reverse winding error
(See page 5-10
for the corrective action of service call)
To Next Page
Loading...
