6-65
Machine transportation after setup > Procedure for the main unit transportation (Truck transportation)
[CONFIDENTIAL]
U034 Leading edge timing adjustment (In case of BK head replacement)
1
Go into U034 Adj Paper Timing.
2
Select [Start Position].
• Select [Full (Shift)] for lead edge timing adjustment in full speed.
3
Press [System Menu/Counter] key.
• Set feed cassette or paper speed in Test Print (PG) mode.
• When the optional PF is installed, set the paper feeding source other than MP tray.
4
Press [Start] key to output adjustment chart.
5
Press [System Menu/Counter] or [Stop] and get back to Full (Shift) screen.
• Select [1st Side] in case of first side adjustment and enter value. [mm]
• Select [2nd Side] in case of second side adjustment and enter value. [mm]
6
Change the setting value by using [+] [-] keys or the numeric keys.
• When the setting value is increased, the image moves backward, and it moves forward when the setting value
is decreased.
• [Full (Shift)]: (Output from cassette, MP tray other than following setting) * With feed accelerating before registration
• [Full]: (Output to MP tray or selecting low paper feed speed) * Without feed accelerating before registration
• [Full (SRA3/12x18)]: * Print Full speed for SRA3/12x18 with duplex only
• [Half]: * Print for 1200dpi or IJ mat paper
7
Press [Start] key to fix the setting.
One side
or
First side of duplex
Second side of duplex
Full(Shift)
U034
01
02
1st Side
2nd Side
-1.50
0.00
Full
U034
01
02
1st Side
2nd Side
-1.50
0.00
Half
U034
01
02
1st Side
2nd Side
-1.50
0.00
21.5mm
To Next Page
Loading...
