10-27
Troubleshooting > Troubleshooting
1105
Failed to send via SMB. Check the following settings.
[
System Menu/Counter
] key > [
System/Network
] >
[
Network
] > [
TCP/IP Settings
] > [
Protocol Detail
] >
[
SMB Client (Transmission)
]
page 8-26
Failed to send the e-mail. Select [
On
] of the SMTP settings on the Command
Center RX.
page 2-53
Failed to send via FTP. Check the following settings.
[
System Menu/Counter
] key > [
System/Network
] >
[
Network
] > [
TCP/IP Settings
] > [
Protocol Detail
] >
[
FTP Client (Transmission)
]
page 8-26
1106
Failed to send the e-mail. Check the sender address of SMTP on the Command
Center RX.
page 2-53
1131
Failed to send via FTP. Enable the SSL.
[
System Menu/Counter
] key > [
System/Network
] >
[
Network
] > [
Secure Protocol
] > [
SSL
]
page 8-30
1132
Failed to send the e-mail. Check the following of the SMTP server.
• Is SMTP over SSL available?
• Is the encryption available?
Refer to the
Command
Center RX
User Guide
.
Failed to send via FTP. Check the following of the FTP server.
• Is FTPS available?
• Is the encryption available?
—
2101
Failed to send via SMB. Check the network and SMB settings.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
• Host name and IP address
• Port number
—
Failed to send via FTP. Check the network and FTP settings.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
• Host name and IP address
• Port number
—
Failed to send the e-mail. Check the network and Command Center RX.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
• POP3 server name of the POP3 user
• SMTP server name
page 2-53
Error
Code
Message Corrective Actions
Reference
Page
To Next Page
Loading...
Need help?
General
Weight and Dimensions
