Kyocera ECOSYS P6030cdn - Page 150

6-54 Using the Operation Panel
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
POP3 (POP3 setting)
Select whether or not to receive email using POP3.
1 Press  while >Protocol Detail > is displayed.
2 Press  or  repeatedly until >>POP3 appears.
3 Press [OK]. A blinking question mark (?) appears.
4 Select On or Off using  or .
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
RAW Port (RAW Port setting)
Select whether or not to communicate using RAW Port.
1 Press  while >Protocol Detail > is displayed.
2 Press  or  repeatedly until >>RAW Port appears.
3 Press [OK]. A blinking question mark (?) appears.
4 Select On or Off using  or .
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
LPD (LPD setting)
Select whether or not to receive documents using LPD as the network
protocol.
1 Press  while >Protocol Detail > is displayed.
2 Press  or  repeatedly until >>LPD appears.
3 Press [OK]. A blinking question mark (?) appears.
4 Select On or Off using  or .
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
HTTP (HTTP setting)
Select whether or not to communicate using HTTP.
1 Press  while >Protocol Detail > is displayed.
2 Press  or  repeatedly until >>HTTP appears.
>>POP3
? Off
>>RAW Port
? On
>>LPD
? On