10-12
Troubleshooting > Troubleshooting
Part of the image is
periodically faint or shows
white lines.
― Open and then close the rear cover. page 2-2
― ECOSYS P6235cdn: Select the [Menu]
key > [Adjust/Maint.] > [Service
Setting] > [MC] and decrease the
adjustment value. Decrease the
adjustment value 1 level at a time from
the current value. If there is no
improvement after the value is
decreased by 1 level, decrease by 1
level again. If there is still no
improvement, return the setting to the
original value.
―
Skewed-color printout. ― Run [ColorCalibration]. page 10-20
― Run [Color Regist.]. page 10-20
Colors appear different than
you anticipated.
When printing from a computer
Adjust the color using the printer driver.
―
The previous image remains
and lightly printed.
― ECOSYS P6235cdn: Select the [Menu]
key > [Adjust/Maint.] > [Service
Setting] > [MC] and increase the
adjustment value. Increase the
adjustment value 1 level at a time from
the current value. If there is no
improvement after the value is
increased by 1 level, increase by 1 level
again. If there is still no improvement,
return the setting to the original value.
―
The color toner is empty. Do you want to continue printing in black
and white?
If the black toner is remained, the
machine continues printing in black and
white by selecting [Print in B & W] of
[ColorToner Empty].
page 8-27
The machine is emitting
steam in the area around the
paper ejection slot.
Check the room temperature to see if it
is low, or if damp paper was used.
Depending on the printing environment
and the paper's condition, the heat
generated during printing will cause the
moisture in the paper to evaporate, and
the steam emitted may look like smoke.
This is not a problem, and you can
continue printing. If the steam concerns
you, raise the room temperature, or
replace the paper with a newer, dryer
paper.
―
Symptom Checkpoints Corrective Actions
Reference
Page
To Next Page
Loading...
Need help?
General
Weight and Dimensions
