4.
Setting Up and Interfacing (Standard KPDL driver) [CD-ROM Drive Name]:\drivers\[Language]\kpdl\9x 8. Select Kyocera FS-1750 or Kyocera FS-3750
click on Next ], and follow the on-screen instructions to install. Once the driver has been properly installed, a Kyocera printer icon will be added to the
printers folder. When printing under Windows 95/98, be sure to set the emulation of this printer to PCL 6 (default setting). Windows 3.
1 To install the printer driver for Windows 3.1, proceed as follows: 1. Insert the Kyocera Digital Library CD-ROM in your CD-ROM drive. 2. Start Windows
on your computer. 3. Double click on Control Panel. 4. Double click on Printers. 5.
Click on Add. 6. Click on Install. 7. Select Install Unlisted or Updated Printer under List of Printers. 8. Click Install. 9. Select the drive into which you
inserted the Kyocera Digital Library CD-ROM, and then select one of the following directories. (Standard PCL5E driver) [CD-ROM Drive
Name]:\drivers\[Language]\pcl\3x (Standard PCLXL driver) [CD-ROM Drive Name]:\drivers\[Language]\pcl\3x\enhanced (Standard KPDL driver) [CD-
ROM Drive Name]:\drivers\[Language]\kpdl\3x Click OK and follow the instructions that appear on the screen.
10. When the driver is installed, click on Close to close Control Panel. 1-18 1.5. MP (Multi-Purpose) Tray Feeding 1.
5. MP (Multi-Purpose) Tray Feeding The MP tray is incorporated on the front of the printer. It can be used in one of two modes: first mode or cassette mode.
The MP tray can hold about 100 sheets of paper (A4 size, 0.1 mm thickness).
If you set a full number of sheets for sizes bigger than A4, it could cause a paper jam. In this case, set a lower number of sheets than the full amount, confirm
that there will be no paper jams and then commence printing. First Mode (Automatic Manual Feeding) The printer automatically feeds any paper placed on
the MP tray even if another paper source is selected. After all paper in the MP tray is printed, paper will be fed from the paper source originally set. (This is
the factory set default.) Cassette Mode The cassette mode provides faster printing speed than the first mode. Approximately 100 sheets of paper can be
continuously fed in this mode. Duplex Printing from the MP tray In first mode, be sure to set the MP tray to the same paper size and paper type as set for the
current cassette. If the paper size or type differs, a paper jam may result. Also note that it is not possible to select the MP tray as the current cassette and
perform duplex printing.
We therefore recommend that duplex printing be performed from the paper cassette. An optional duplexer (DU-21) is required to perform duplex printing.
Selecting the MP Tray 1. Taking hold of the front of the printer as shown in the figure, open the MP tray by pulling towards you. MP Tray 2. Withdraw the sub
tray as shown in the diagram. Sub Tray 1-19 1.5. MP (Multi-Purpose) Tray Feeding 3. Raise the paper protector bar until it locks in the up position.
Then adjust the paper guides to the size of the paper being fed. Protector Bar Paper Guides 4. Check that the message 5HDG\ is displayed in the printer's
message display, and that the ON LINE indicator is lit. 5. Set the paper source to the multi-purpose tray by pressing the FEED key until the message display
indicates 03ýWUD\.
The multi-purpose tray indicator on the control panel will flash, and $GGýSDSHU will be displayed. 6. Press the MODE key. Then use + or keys to display
3DSHUýKDQGOLQJýýý!. 7.
Press the (Form Feed) key to display !03ýWUD\ýVL]H or !ý03ýWUD\ýW\SH, then press the ENTER key so you can set the paper size or type to be fed from
the MP tray. See Mode Select Menu at the end of this manual. The following pages explain the use of the MP tray in the Cassette Mode and First Mode. First
Mode (Automatic Manual Feeding) The printer automatically feeds the paper placed on the MP tray regardless of the current paper source selection. To use
the first mode (automatic manual feeding mode), simply place a sheet of paper on the MP tray in the same manner as above, even while the printer is
presently feeding the paper in the printer's cassette.
You're reading an excerpt. Click here to read official KYOCERA
FS-1750 user guide
http://somemanuals.com/dref/324820
To Next Page
Loading...
