Kyocera FS-3040MFP+ - Page 107

2MF/2MG
1-4-4
Paper
feeder
0030 Paper does not arrive at the
PF paper feed sensor 1 within specified
time from start of paper feed (paper feed from paper feeder 1).
C
Paper does not arrive at the
PF paper feed sensor 1 within specified
time
of the PF paper feed sensor 2 turning on (paper feed from paper
feeder 2)
.
C
Paper does not arrive at the
PF paper feed sensor 1 within specified
time
of the PF paper feed sensor 3 turning on (paper feed from paper
feeder 3)
.
C
0031 Paper does not pass the
PF paper feed sensor 1 within specified time
of the PF paper feed sensor 1 turning on.
C
0032 Paper remains at the
PF paper feed sensor 1 when power is turned
on.
C
0040 Paper does not arrive at the
PF paper feed sensor 2 within specified
time from start of paper feed (paper feed from paper feeder 2).
D
Paper does not arrive at the
PF paper feed sensor 2 within specified
time
of the PF paper feed sensor 3 turning on (paper feed from paper
feeder 3)
.
D
0041 Paper does not pass the
PF paper feed sensor 2 within specified time
of the PF paper feed sensor 2 turning on.
D
0042 Paper remains at the
PF paper feed sensor 2 when power is turned
on.
D
0050 Paper does not arrive at the
PF paper feed sensor 3 within specified
time from start of paper feed (paper feed from paper feeder 3).
E
0051 Paper does not pass the
PF paper feed sensor 3 within specified time
of the PF paper feed sensor 3 turning on.
E
0052 Paper remains at the
PF paper feed sensor 3 when power is turned
on.
E
Document
processor
9000 The DP timing sensor (DPTS) does not turn on within specified time
during the first sheet feeding (Retry 5 times).
I
9001 DP timing sensor (DPTS) turns off within the specified time since
the sensor turns on.
I
9003 During duplex switchback scanning, the DP timing sensor (DPTS)
does not turn off within specified time.
I
9004 During duplex switchback scanning, the DP timing sensor (DPTS)
does not turn on within specified time since original switchback
operation starts.
I
9011 The DP or DP top cover is opened during original feeding. I
9401 The DP timing sensor (DPTS) does not turn off within specified time
of the DP timing sensor (DPTS) turning on.
I
*: Refer to figure 1-4-2 for paper jam location (see page 1-4-2)
Section Code Conditions
Jam
location